The Easton H Nock is precision-molded to be a perfect press-fit replacement nocks for Easton ST Epic, ST Excel, ION, Bloodline, and Wildthing carbon arrows. They are also replacement nocks for our Traditional Only® 600 spine. Weigh approximately 10 grains each. Sold by the dozen. ...read more
Reinforce your Gold Tip Traditional Classic and Traditional Classic XT carbon arrows... read more
The Black Eagle "M" Micro-Nock is 100% Polycarbonate. Sturdy and dependable, it's... read more
All new HD Orange! 30% brighter than previous models. Featuring new and... read more
The NOCKturnal™ lighted nock is a breakthrough design that is more affordable... read more
Bowhunters and target shooters expect a lot from their arrows. That's why... read more
Perfect dotting nock
I'm a hunter chose theese nocks for my full metal jacket arrows which are the best ones I've shot theese nocks are perfect for the 6mm shafts
Easy to replace
Nock replacement is an easy way to get that perfect string fit.
Great Nocks!
I use this nock with my Easton ST Epic Carbon shafts. They work great!
Not great for MY application............
Understand that this review is about my bow/bowstring only and cannot be interpreted as a total review for other applications. I'm using this nock on my ST Epics which are great arrows and a great nock except for use on my primitive bow with a flemish bowstring using .021 serving. The nock literally "snaps" onto the .021 serving and thusly takes some of the power of the bow to "un-snap"… read more at the moment of truth. Perhaps this is not an issue when the arrows are being used with high end bows or compound bows. For the target shooter/stumper with primitive bows this can be an issue. The ST Epic carbon arrows are great to use as they are almost indestructible but if I was custom ordering, I would look for a more traditional nock for my application OR use a smaller serving i.e. .018
The Easton H nock will fit the aftermath arrows you have.
Yes
I reach in with a pointed hook and grab the edge and pull them out or you can use needle point pliers if you some some of the nock sticking out. When you reinstall the nock insert the string groove on the nock perpendicular (90 degrees) from the cock feather.
I believe the Carbon Raider uses an .246" inside diameter nock, so you would need one of the following: https://www.3riversarchery.com/easton-microlite-nocks.html or https://www.3riversarchery.com/easton-super-3d-nocks.html
I believe the Carbon Raider is a .246" inside diameter, and the H nock is made for a .231" ID. So they will not fit. You will need the Super 3D nock or MicroLite nocks.
They all have S or Super Nocks except for the 600 spine which take an H nock.
Yes these are the factory nocks for that shaft.
Yes these will fit the Center shot 400 shafts.
To get a tighter fitting nock you would have to use the Uni bushing. (0150X) Using that bushing you would need to purchase the G nock as well (6754X).
Sold by the dozen.