Steel Screw-In Field Points - Heavyweight Review

They will be slightly bigger but the have a taper back to 5/16" so it meets up flush at the insert

The Gold Tip shaft is extremely tough and durable at all sizes. I personally have been shooting them since they first came to market.My preferred make up includes a brass 100gr. Insert and a 200gr.screw in field point on a 5575/400 size shaft for targets. And I replace that with a 100gr. Brass glue on insert with a 200gr. Grizzly broad head for hunting. Indestructible !! Hope this helps. Bob

It will depend on your shooting form and arrow spine. You may want to get a test kit to try out heavier weights.

Yes these will screw into Axis arrows with the hit inserts. They will be slightly larger than the diameter of the shaft.

I shoot the 200 grn., they measure 1-1/4" (one and a quarter inches).

Yes they will. They taper to a 5/16 on the back

As long as the Beman arrows have a standard 8 x 32 screw threads. Once in a while, you'll get one that doesn't want to go in. Just file off a "hair" around the shoulder and it should work fine.

Yes these will work great Sent from my iPadLori Rieberger

Yes, the thread size is the same, so they will fit. The weight depends on how closely matched your arrow spine is in regards to the weight of the bow.

you would go with the 5/16 it wont hurt anything being larger

Yes, they will work.

These field points are 5/16 dia. and they will work on Carbon Express 350 although there may be a slight step from the point diameter where it meets the arrow shaft diameter.

Yes, they should work fine.

not sure mate, i used them on easton gamegetter shafts, they appear to be the normal thread size so i would assume they should fit conventional shafts like the fmj.. hope that helps.

Yes. I shoot the exact points in FMJ 340’s and 300’s. Work great.

Sure will. I also use the 50/75 grain inserts and 200 gr field tip. Arrows hit like a hammer! Sent from my iPhone

9/32 points are ideal and can be pulled from a bag target. If super heavy weight points are desired then 5/16 can be used in a block type target without much problem.

Yes.

Yes, they will work.

The heavy {300} screw in field points fit my 55/75 gold tip traditional shafts with 100gr brass inserts, just fine --shoot them almost everyday

Yes, I don't have them in front of me, but I don't remember having any problems with them fitting. If memory serves, they were a perfect fit. Hope this helps. By the way, you will love the FOC and outstanding penetration you will get with that combination. It is very similar to mine. Good luck. Sent from my iPhone

Yes. The diameter of the field point is slightly larger but they work well and will fit. I use the same on 300 spine fmj's

I think they will work just fine. I use them on the gold Tip inserts provided with the shafts.