Aluminum Tube Cutter Review
Featured Deal
Aluminum Tube Cutter
New
From $17.50
Get DealAluminum Tube Cutter
Handy small tube cutter, perfect for precision cutting of aluminum arrow shafts. Recommended to pair with Shaft Deburring Tool. ...read more
MSRP:
$17.50
$17.50
Used Price:
$12.25
$12.25
Sale Price:
$15.75
$15.75
Aluminum Tube Cutter For Sale
Most Popular Arrow Tools & Accessories
MTM Arrow-Plus Case
Rugged arrow cases from MTM are a traveling archer's favorite. Made of... read more
$49.99
98%
98%
Ace Spine-Master Spine Tester
Finally! A spine tester for the home wood arrow builder that won't... read more
$149.99
96%
96%
Great Northern Feather Processing Jig
With the built-in guide controls, you can produce precision grinds to both... read more
$154.99
92%
92%
Replacement Indexer for Bitzenburger Dial-O-Fletch Fletching Jig
Replacement (or extra) fletching indexer for the Bitzenburger Dial-O-Fletch fletching jig. Looking... read more
$22.99
90%
90%
Bitzenburger Bearing Spring
Replacement (or extra) bearing spring for the Bitzenburger Dial-O-Fletch fletching jig. Sold... read more
$1.50
Not Rated
Not Rated
Aluminum Tube Cutter Reviews
Productt ok
A
3 years ago
To cut carbon arrows
Aluminum Tube Cutter Questions and Answers
Asked by
Mr. Hunterken
5 years ago
Is this tool compatible for cutting arrow shafts without collapsing the shaft
Yes this will cut aluminum shafts without collapsing them. You w
5 years ago
Yes this will cut aluminum shafts without collapsing them. You will want to make sure that you are not putting too much pressure when using it.
Yes. Just twist the knob very lightly and take your time. You ca
5 years ago
Yes. Just twist the knob very lightly and take your time. You can also insert a slightly snug fitting wooden dowel to support the tube. The size of dowel depends on the ID of the shaft.
Yes. Go slow and slowly increase the depth of the cutter.
Tom St
5 years ago
Yes. Go slow and slowly increase the depth of the cutter. Tom Stevens
Yes, very, very light pressure, with patience, and this works gr
5 years ago
Yes, very, very light pressure, with patience, and this works great on aluminum shafts. I do also use a debit ring tool afterwards just for a light touch up.
The tool will not collapse the shaft. You control the amount of
5 years ago
The tool will not collapse the shaft. You control the amount of pressure. You clamp it just lightly enough to start cutting and continue to tighten as the cut gets deeper and deeper. It's a good little tool and I recommend it.