Finally! We've been looking for these for a long time. Tough, spring, metal clips. Used for displaying arrows, securing arrows in arrow boxes, holding shafting in arrow production, and many more uses. ...read more
Rugged arrow cases from MTM are a traveling archer's favorite. Made of... read more
Finally! A spine tester for the home wood arrow builder that won't... read more
With the built-in guide controls, you can produce precision grinds to both... read more
Replacement (or extra) fletching indexer for the Bitzenburger Dial-O-Fletch fletching jig. Looking... read more
Replacement (or extra) bearing spring for the Bitzenburger Dial-O-Fletch fletching jig. Sold... read more
I have bought this product TWICE !!!
See use above
Euro mount
Great product
Great hard to find item. Plan on buying more.
These are very specifically made for displaying arrows. Works for wooden shafts and carbon alike.
Just what I needed
Good product
Like the clips work well.
Used in hand crafted wooden arrow box. Disappointed there were no screws supplied.
Much better clips than some of the plastic ones offered
product is used for arrow storage and will hold up to wear longer than plastic ones offered by others.Make sure to order extras so that they can be used as needed or other projects.
I did buy this product
Only negative was it did not include screws to mount them.
These clips are rough on arrows. I do NOT recommend them.
I've recently gotten into building arrows. I built a drying rack for arrows and bought these clips thinking they looked ideal for holding arrows while they dried. Then, I started noticing little scratches in the arrows where the clips attached. Save your money and come up with an alternative. I bought rubber-coated binder clips from Office Depot and they work much better.
Very handy little product.
I enjoyed using them to build my own bow and arrow rack out of black walnut.
They work great.
display arrows holds arrows nicely.
No the screws are not included with the clips .
You can purchase them by the dozen, so you will need 3 dz.
The mounting hole is 1/8" diameter
They are approximately .75"X.5"X.25" and weight approximately 20 grains
I imagine you could add some of our "Super Pad" material (Item Number 3555x) to the inside of them. I haven't tried it, but I would think it might work. It's relatively inexpensive and would be worth trying.
I am planning to purchase some of these clips myself. I am going to try either dipping them in Plasti Dip, or using heat shrink tubing on them.
try loosening the screw up until you get the grip you desire.
You will be able to hold up to 23/64 depending on how tight you set the clip.
They are a spring clip so they should hold any size arrow shaft. You can't go too big on your mounting screws but I tried my 11/32 shafts and also tried some old 2512 aluminium shafts and they worked. Sent from my Verizon Wireless Phone
Howdy I got these arrow clips especially for my 5/16 carbon arrow shaft. However I can also clip my 11/32 wood arrows.. Hope this helps
I've found them to be pretty flexible so it varies. My arrows are 1 cm in diameter and I wouldn't recommend going more than a few millimeters larger, but there is some give. Smaller wouldn't be a problem.
This clip is realy adjustable for any size arrow up to 3/8". Use small screws to install clip - tighten or losein to fit desired arrow size. Tightening will pinch the clip because of the construction of the clip - try it and you will see. (smile)
You can adjust them to fit Any size!
all sizes
The mounting hole for the metal clips is 1/8".
The mounting hole is 1/8 inch diameter.
Sorry, but we just sell the clips.
No, there are no screws included.
No screws are included.